Craftsman 917.252711 Owner's Manual page 26

TO REPLACE HEADUGHT
BULB
® Raise hood.
o Put! bulb holder out of the hole in the backside of the
grill.
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
Check wiring. See electrical wiring diagram in the
Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.
ENTS
TO REMOVE HOOD AND GRmLL ASSEMBLY
(See Fig. 31)
- Raise hood.
Unsnap headlight wire connector.
, Stand in front of tractor. G rasp hood at sides, tilt toward
engine and lift off of tracton
• To replace, reverse above procedures.
HOOD
HEADLIGHT
WiRE
CONNECTOR
FIG. 31
26