Advertisement
Available languages
Available languages
KEEP TOOL
CLEAN
PeriodicatIy blow out aII air passages
with dry compressed
air. All plastic
parts should be cleaned with a soft
damp cioth. NEVER use solvents to
clean plastic parts. They couId
possibly dissolve or otherwise
damage the material.
Wear ANSI Z87.1
safety glasses while using
compressed
air.
LUBRICATION
This toot has been lubricated with a
sufficient amount of high grade
lubricant for the life of the unit under
normal operating conditions.
No
further lubrication is necessary.
BRUSH
INSPECTION
For your continued safety and
electrical protection,
brush inspection
and replacement
on this tool should
ONLY be performed
by Sears Parts &
Repair Centers in the United States.
At approximately
100 hours of use,
take or send your toot to your nearest
Sears Parts & Repair Center in the
United States to be thoroughly
cleaned and inspected. And if
necessary, have worn parts replaced,
lubricated with fresh lubricant, new
brushes installed, and performance
tested.
Any Ioss of power before the above
maintenance check may indicate the
need for immediate servicing of your
tool. DO NOT continue to operate
too! under this condition.
Return the
toot to a Sears Parts & Repair Center
in the United States for immediate
service.
A complete line of accessories
is
available from your nearest Sears
store, Craftsman outlet, or through
the www.sears.com/craftsman
website.
Since accessories
other than those offered by Sears
have not been tested with this
product,
use of such accessories
coumd be hazardous.
For safe
operation,
use onJy accessories
sold by Sears.
A03284
16-ENG
Advertisement
