Advertisement
PRECAUTIONARY MEASURES
IMPORTANT:
If the suction opening in the unit or the hose is BLOCKED, switch off
the vacuum cleaner and remove the blocking substance before you
start the unit again.
1. Do not operate the vacuum cleaner
too close to heaters, radiators or
cigarette butts.
2. Before inserting the power plug into
the wall outlet, make sure that your
hands are dry.
3. Before you start vacuuming, make
sure to remove large or sharp objects
that might damage the dust cup
debris screen.
4. When pulling out the power plug
from the wall outlet, pull the plug not
the power cord.
5. Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
6. Do not use without ALL filters in
place.
Warning:
Hold the plug when
rewinding the cord. Do not allow the
cord to whip when rewinding.
3
OPERATING INSTRUCTIONS
Motor Thermostat
IMPORTANT:
This unit is equipped
with a motor protective thermostat. If
for some reason the vacuum cleaner
should overheat, the thermostat will
automatically turn the unit off. Should
this occur:
•
Push the On/Off button once.
•
Disconnect the plug from the
power source.
•
Check the source of overheating
problem. (i.e. clogged hose or
filter)
TROUBLE SHOOTING GUIDE
PROBLEM
POSSIBLE REASON
1.
Power cord not firmly plugged into
outlet.
VACUUM WILL
2.
No power in wall outlet.
NOT OPERATE
3.
Needs servicing.
4.
Thermostat has tripped.
1.
Dust cup is full.
VACUUM WILL
2.
Unit clogged.
NOT PICK-UP OR
3.
HEPA Filter needs cleaning or
SUCTION POWER
replacing.
IS WEAK
4.
Debris screen needs cleaning.
5.
Filters need cleaning
DUST ESCAPING
1.
Dust cup is full.
FROM VACUUM
2.
Dust Cup is not installed correctly.
VACUUM, HOSE
1.
Hose clogged.
OR BRUSHES
2.
Dust cup is full.
WILL NOT PICK-UP
• If clogged hose or filter is found,
unclog the hose and replace the
filters.
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for
45 minutes, plug in the cleaner
and push the On/Off button. The
vacuum should start again.
• If the vacuum still does not start,
contact customer service at
1-800-798-7398.
POSSIBLE SOLUTION
1.
Plug unit in firmly.
2.
Check fuse or breaker. Replace
fuse/reset breaker.
3.
Call 1-800-798-7398.
4.
Turn the unit off and unplug from
outlet. Allow unit to cool down,
then restart.
1.
Empty and clean dust cup.
2.
Turn unit off and unplug from
wall outlet. Remove Dust Cup
Filter and check for object(s) in
air duct and remove.
3.
Clean or replace HEPA Filter.
4.
Clean debris screen.
5.
Clean Filters
1.
Empty and clean dust cup.
2.
Review Dust Cup instructions.
1.
Remove hose and/or brushes.
Remove obstruction from hose
and /or brush.
2.
Empty and clean dust cup.
8
Advertisement
