To Connect The Mouse, Keyboard, And Lan - Agilent Technologies Infiniium 90000 Q-Series User Manual

To connect the mouse, keyboard, and LAN

Mouse and
A mouse and keyboard can be plugged into either USB host ports or the
Keyboard
PS/2 ports.
There are several USB host ports on the back and front panel of the
oscilloscope that can be used. (The USB device port is used for remote
control of the oscilloscope from a PC.)
When using the PS/2 ports, the mouse and/or keyboard must be plugged
in prior to turning on power to the oscilloscope.
LAN Cable
Connect your LAN cable to the RJ- 45 connector on the back panel of the
oscilloscope.
After you have connected to the LAN card, you must set up the network. Before you try to
N O T E
set up your network, you should exit the oscilloscope application.
If you do not know how to set up a network in the Windows 7 operating system, see your
network administrator or use the Windows 7 operating system's online help.
Mouse and
keyboard
connectors
Figure 2 Back Panel
Agilent Infiniium 90000 Q-Series Oscilloscopes User's Guide
LAN connector
(Non Auto-
MDIX)
DVI
USB host
ports
Trig Out Aux Trig 10 MHz in
Setting Up the Oscilloscope
CAUTION: Power down
Removable
instrument before
Hard Drive insertion or removal
of hard drive.
Device
USB
100 - 240V
device port
N O T I C E
Well-regulated power
required for 100-120V
operation.
CAUTION: Use only with
power cable specified by
owner's guide.
WARNING: Maintain
ground to avoid electric
shock.
10 MHz out 100 MHz in 100 MHz out
1
AC power cord
plugs into here
~ Line
1350W Max
50/60 Hz
N10149
169323
17