To Connect The Mouse, Keyboard, Lan, Printer, And Gpib Cable - Agilent Technologies Infiniium 80000 Series Service Manual

Table of Contents

To connect the mouse, keyboard, LAN, printer, and GPIB cable

Mouse. Plug the mouse into the mouse connector on the rear panel of the oscilloscope.

While you can operate many oscilloscope functions using only the front-panel keys and

knobs, you will need the mouse to access advanced oscilloscope functions through the

graphical interface, or to find out more about the oscilloscope through the built-in

information system.

Keyboard. Plug the keyboard cable into the keyboard connector on the rear panel of the oscilloscope.

A keyboard must be plugged into the oscilloscope before the Windows operating system

has started booting.

LAN Cable. Connect your LAN cable to the RJ-45 connector on the rear panel of the oscilloscope.

Depending on your building's LAN configuration, you may need to set up the

oscilloscope's network configuration after connecting the LAN cable to the

oscilloscope. If your building's network uses DHCP, many parameters will already be

compatible. Before you set up the network configuration, you should exit the

oscilloscope application. If you do not know how to setup the network, see your network

administrator or use the Windows XP on-line help.

Printer Cable. If you have a USB printer, you will need to connect its cable to one of the four USB ports on the

rear panel, or to the USB port on the front panel.

If you have a parallel printer, you will need to connect its parallel printer cable to the Parallel

Printer connector on the oscilloscope.

GPIB Cable. If you will be controlling the oscilloscope through the GPIB, attach your GPIB cable to the GPIB

connector on the rear of the oscilloscope.

Figure 2-5

Rear Panel

Note:

Your instrument's rear panel configuration may differ from this diagram. Connect the cables based on your instrument's

configuration.

Parallel

Printer

Mouse

Keyboard

Chapter 2: Setting Up the Oscilloscope