GE Monogram ZISS480DRISS Owner's Manual page 22

(;are and (;leaning
Built-In I¢_if)'igerators
Type 2 bulb
, placemerzt
22
NOTE: Before replacing the bulbs, review
the light bulb intormation and WARNING.
Replacing Type 2 bulbs in lamps located inside
the light shield at the top of the fresh food
compaxtment:
1. Set the Master I,ight switch to the OFF
position (see I:_sing"the Master Lit{q_tswitHO
and allow the lamps to cool.
2. If the _'_ater Filter Cartridge is installed,
remove it and replace with the filter
bypass plug.
3. Holding the light shield with one hand,
rotate the support tabs tmtil they clear the
fl'ont of the light shield. Then push back on
the light shield, lower the shield at the fl'ont
and take out.
4. Remove the 4 screws securing the light
housing to the ceiling. There are two screws
at the fl'ont and two at the back.
I,ower the light housing at the fl'ont, then
pull it toward you so the tabs at the back of
the light housing come out of the slots on
the back wall. The lamp assemblies will
release fl'om the holders.
Turn the lamp
protector to
access the bulb.
NOTE: Always fl)llow bulb manufiicmrer's
directions fin" handling and replacing bulbs.
7. Remove the bulb by holding the base and
pulling straight out. P,eplace with a new bulb
and replace the lamp protector.
WARNING - ,amp p r.te, t ,,rs
must be replaced or the heat _i'om the bulb
could damage the refl'igerato,;
AVERTISSEMENT •
o
Vous devez remettre en place les Ocrans
protecteurs des ampoules pour ne pas
endommager votre r_fi'ig_ratem" avec la
chaleur produite par les ampoules.
%pport tabs Upperlight
shield
Screws
Slots
gbt housing
8. Holding up the light housing, place each
lamp assembly in its holder. Feed the
attached wires through the slots and tuck
the wires outside the side of the light
housing.
10.
11.
Insert the tabs on the back of the light
housing in the slots on the back wall.
Raise the light housing into position and
secure with the _bur screws.
Replace the light shield and rotate the
Stlpport
tabs back out so they support the
fl'ont of the shield.
Remove the filter bypass plug and replace
with the _'_ater Filter Cartridge. Reset the
Master Light switch to the ON position.