Advertisement
The operation of any tractor can result in foreign objects thrown into the
eyes, which can result in severe eye damage. Always wear safety glasses
or eye shields while operating your tractor or performing any adjustments or
repairs. We recommend a wide vision safety mask over spectacles, or stan-
dard safety glasses.
HOW
TO USE YOUR
TRACTOR
Your tractor is equipped with an operator
presence Sensing switch. When engine is
running, any attempt by the operator to
leave the seat without first setting the
parking brake will shut off the engine.
TO SET PARKING
BRAKE
• Depress clutch/brake
pedal into full
=BRAKE" position and hold.
• Place parking brake lever in =EN-
GAGED" position and release pressure
from clutch/brake pedal. Pedal should
remain in =BRAKE" position. Make sure
parking brake will hold tractor secure.
Throttle
Push-In to
Attachment Clutch
Control
"Disengaged"
Switch Pull Out To
_'-__
Engage'\
Clutch/_ake
.n;_=_=n=_,"Parking
Brake
Pedal=Drive .
pC_'_ -_'"
=Engaged"
Position
Position
STOPPING
MOWER
BLADES -
• To stop mower blades, move attach-
ment clutch switch to "DISENGAGED"
position.
GROUND
DRIVE -
• To stop ground drive, depress
clutch/brake pedal into full "BRAKE"
position.
• Move motion control lever to neutral (N)
position.
IMPORTANT:
The motion control lever
does not return to neutral (N) position
when the clutch/brake pedal is depressed.
ENGINE
-
• Move throttle control to slow :ppsition.
NOTE:
Failure to move throttle control to
slow position
and allowing engine to idle
before stopping may cause engine to
"backfire'.
Turn ignition key to =OFF" position and
remove key. Always remove key when
leaving tractor to prevent unauthorized
Use.
• Never use choke to stop engine.
IMPORTANT:
Leaving the ignition switch
in any position other than "OFF" will cause
the battery to be dishcarged (dead).
NOTE:
Under certain conditions when
tractor is standing idle with the engine run-
ning, hot engine exhaust gases may
cause "browning"
of grass. To eliminate
this possibility,
always stop engine when
stopping tractor on grass areas.
_,
CAUTION:
Always stop tractor com-
pletely, as described above, before leaving
the operator's position; to empty grass
catcher, etc.
THROTTLE
CONTROL
Always operate engine at full throttle.
• Operating engine at less than full throt-
tle reduces the battery charging rate.
• Full throttle offers the best bagging and
mower performance.
CHOKE
CONTROL
Use choke control whenever
you are start-
ing a cold engine. Do not use to start a
warm engine.
• To engage choke control, pull knob out.
Slowly push knob in to disengage.
TO MOVE FORWARD
AND BACKWARD
The direction and speed of movement is
controlled by the motion control lever.
• Start tractor with motion control lever in
neutral (N) position.
• Release parking brake and clutch/brake
pedal.
• Slowly move motion control lever to
desired position.
TO ADJUST
MOWER
CUTTING
HEIGHT
The cutting height is controlled by tum-
ing the height adjustment knob in
desired direction.
• Turn knob clockwise (G) to raise cutting
height.
.
•Tum
KnOD counterclockwise
(_)to
lower cutting height.
The cutting height range is approximately
1-1/2" to 4-1/2".
The heights are mea-
sured from the ground to the blade tip with
the engine not running.
These heights are
14
Advertisement
