Craftsman 486.248471 Operator's Manual page 16

STEP 27: ADJUST LiFT STRAPS
(SEE FIGURE 26)
Make sure the nuts and bolts in the Siftstraps are
loose enough to turn by hand, Stand on the right side
of the scoop and hold the lift handle as far forward
as it wilt go while you tighten one of the nuts in the lift
straps, You can let go of the Sifthandle to tighten the
other three nuts in the lift straps,
STEP 29: CHECK DUMPING OPERATION
With the scoop in the transport position, squeeze the
dump trigger and push down on the dump handle
to dump the bucket, Release the dump trigger and
lift up on the handle to lock the bucket in the upright
position, If the dump control pin passes underneath
the tilt bracket instead of locking into it, move the pin
stop bracket on top of the bucket farther towards the
rear, if this does not work, repeat steps 26, 27 and 28,
FIGURE 26
STEP 28: ADJUST TILT STOP BRACKETS
(SEE FIGURE 26}
, Raise the scoop until it locks in the TRANSPORT
position, Push the tilt stop brackets (OO) on each side
of the bucket down against the lift frame arms, and
tighten the nuts,
FIGURE 27
16