Craftsman 486.248471 Operator's Manual page 10

STEP11: iNSTALL LIFTHANDLE TUBE
(BEEFIGURE 10)
install t helifthandle tubeintotheindex bracket u sing
two5/16"x 1-3/4" hexbolts(G)and5/16"nylock nuts
(R).
FIGURE 10
STEP12: iNSTALL LIFTHANDLE TUBEEXTENSION
(SEEFIGURE 11)
, install t helifthandle tubeextension o nthelifthandle
tubeusinga 1/4"x 1o3/4" hexbolt(H)and1/4"nylock
nut(S),
LiFT HANDLE
TUBE EXTENSUON
1/4" x 1-314"
HEX BOLT (B)
\
%
\
FIGURE 11
1/4" NYLOCK NUT (S)
UFT HANDLE
TUBE
STEP 13: iNSTALL LIFT CABLE
(SEE FIGURE 12)
Squeeze the lift trigger and slide the anchor end of the
lift cable (short) into the hole in the trigger, Release
the trigger and guide the cable through the slot in
the bottom of the trigger and trigger housing, Insert
the end of the plastic cable covering into the trigger
housing,
Connect the hooked end of the lift cable into the index
rod, and install the threaded cable adjuster into the
notch in the top of the index bracket, placing a nut on
each side of the notch,
Adjust the cable adjustment nuts so that when the
trigger is squeezed, the bottom of the index rod raises
enough to release from the latched position, The index
rod should also lower far enough to lock in the latched
position when the trigger is released,
Attach the lift cable to the lift handle using three cable
ties (NN),
LiFT TRUGGER
LIFT CABLE (SHORT)
/
CABLE
ANCHOR
FIGURE 12
lO