Install Front Scoop On Tractor - Craftsman 486.248471 Operator's Manual

STEP 17: iNSTALL DUMP CONTROL PIN
(SEE FIGURE 16)
,, install a small 1/2" washer (Z) and then the
compression spring (MM) onto the dump control pin.
install the dump control pin into the pin stop bracket.
Make sure the fiat side of the pin faces to the front
when finished.
Connect the hooked end of the dump cable into the
hole in the dump control pin, Insta!l the threaded cable
adjuster down into the notch in the pin stop bracket,
placing a nut on each side of the notch, Adjust and
tighten the adjuster nuts so that the tapered end of
the dump control pin extends 3/4" through the side of
the pin stop bracket,
PiN STOP
BRACKET
\
DUMP CONTROL PUN
SMALL 1/2" WASHER (Z)
/ _SPRmNG
ROOK
I / CABLE
/
ADJUSTER
I "-.d
#10 x 5/8"
-',_\
ROSE TRUSS
CLUP (PP) HEAD BOLT (L)
FIGURE 17
INSTALL FRONT SCOOP ON TRACTOR
STEP 19: IDENTIFY YOUR TRACTOR TYPE
(SEE FIGURE 18)
,, Look under the front of your tractor. If there is a single
mower deck suspension bracket located underneath
the middle of the front axJe, continue on to step 20
on page 13. If your tractor does not have a mower
deck suspension bracket underneath the middle of
the front axle, skip to step 22 or 24 on page 14 for
tractors with dual suspension brackets.
FIGURE 16
STEP 18: INSTALL NOSE CLIP AND SPACER
(SEE FIGURE 17)
,, Secure the dump cable to the back of the bucket
using a hose clip (PP), a #10 x 5/8" truss-head bolt (L)
and a #10-32 nylock nut (U).
Fasten the unused spacer to the lift frame to store it,
using a 5/16" x 1" hex bolt (F) and 5/16" nylock nut
(R), The spacer will be either the 3/8" spacer that was
supplied in the parts bag or the spacer it replaced in
step 7,
FIGURE 18
12
BRACKET