How To Set The Parking Brake :I; How To Change Thecutting; How To Stop The Unit. :I; How To Transport The Unit - Craftsman 536.270211 Owner's Manual

OPERATION
HOW TO SET THE PARKING BRAKE
1 Completely push the clutch/brake pedal forward
2 Lift the parking brake lever (Figure !0)
3. Remove yourfoot from the clutch/brake pedal and then release
the parking brake lever Make sure the parking brake will hold
the unit
4 To release the parking brake, completely push the clutch!brake
pedal forward The parking brake will automatically release
WARNING: Before you leave the operator's position,
,_ move the shift lever to the neutral (N) position. Set the
parking brake. Move the attachment ctutch to the
DISENGAGE position. Stop the engine and remove
the ignition key.
HOW TO CHANGE THE CUTTING HEIGHT
To change the cutting height, raise or lower the lift lever as follows.
1 Move the lift lever forward to lower the mower housing and
back to raise the mower housing
2 When you ride on a sidewalk or road, move the lift lever to the
highest position and move the attachment clutch to the DISEN-
GAGE position.
Parking Brake
Lever
Lift Lever
Figure 10
HOW TO STOP THE UNIT
1. Completely push the clutch/brake pedal forward to stop the
unit. Keep yourfoot on the pedal
2 Move the attachment clutch to the DISENGAGE position.
3 Move the shift lever to the NEUTRAL position
4. Set the parking brake.
,_ WARNING: Make sure the parking brake will hold the
unit.
5. Move the throttle control to the SLOW position
6. To stop the engine, turntheignit]onkeytotheOFFposition Re-
move the key.
HOW TO TRANSPORT THE UNIT
To transport the unit, follow the steps below
1. Move the attachment clutch to the DISENGAGE position
2 Raise the lift lever to the highest position
3.
4.
Move the throttle control to a position between SLOW and
FAST.
To go faster, move the shtft lever to a faster speed
F-99636 !3