To Workbench - Craftsman 113.226431 Owner's Manual

assembly
MOUNTBNG BELT AND DaSC SANDER
TO WORKBENCH
If belt and disc sander is to be used in a permanent
location, it shouldbe fastened securely to a firm supporl-
ing surface such as a workbench.
If mounting to a workbench, holes should be drilled
through supporting surface of the workbench using
dimensions illustrated.
1. The unit should be bo{ted securely using 5/16" screws
and hex nuts (not included). Screw length should be
1-1/2" plus the thickness of the bench top.
2. Locate and mark the holes where belt and disc sander
is to be mounted.
If
24 MIN.
OUTLINE OF SANDER
2 HOLES
3/8 DIAMETER
2"2_/3T2 i [r
Lrl ............. 13-7_B
9/16
3. Drill (2) 3/8" diameter holes through workbench.
4. Place belt and disc sander on workbench aligning
holes on base with holes drilled in workbench.
ALL MEASUREMENTS ARE JNCHES UNLESS OTHERWISE NOTED.
5, Insert two 5/16" screws and tighten hex nuts.
An alternate method of mounting is to fasten belt and
disc sander to a mounting board. The board should be
of sufficient size to avoid tipping of sanderwhile in use,
Any good grade of plywood or chipboard with a 3/4"
minimum thickness is recommended. (Thinner chip-
board can break.)
CAUTION: To avoid injury from tool movement, use
5/16" or larger screws and nuts.
1. Follow instructions for mounting to workbench, sub-
stituting a board 18" x 24" minimum size and using
5/16 inch flat head screws, !ockwashers, and hex nuts
(not included). Screw length should be 1-1/2" plus the
thickness of the mounting board.
NOTE: For proper stability, holes must be counter sunk
so screw heads are flush with the bottom surface of
supporting board.
CAUTION: To avoid Injury from tool movement,
supporting surface where belt and disc sander Is
mou nted shou Id be examined carefully after mount-
lng to Insure that no movement during use can
result. If any tipping or walking is noted, secure
workbench or supporting surface before operating
belt and dlsc sander.
H,IIII IIH, I ,i,ii
/
MOUNTING
HOLE
i!IIi
MOUNTING
HOLE
CLAiVIPING BELT AND DISC SANDER
TO WORKBENCH
The belt and disc sander can be clamped directly to a
workbench using two (2) or more "C" clamps on base of
unit (one clamp on each end of unit).