Burner Caps And Heads - GE P2B918 Owner's Manual And Installation Instructions

Self-cleaning dual fuel convection ranges
Table of Contents

Advertisement

Care and cleaning of the range.
Burner heads
_
Holein
_
burner
head
is removable.
Simply
lift it Off the
range for cleaning, Use a sewing
needle or twist_tie to unclog the
small hole in the burner heads.
32
Burner Caps and Heads
Before removing the burner cops and heeds,
remember their size and location. Replace
them in the some !ocotion after cleaning.
NOTE:Do not usestee! woo! or scouring
powders to cleon the burner ports.
Burner caps
Lift off when cool. Wash burner caps in hot,
soapg water and rinsewith clean water. You
mag scour with a plastic scouring pad to
remove burned-on food particles.
Burner Heads and Oval (Centefl Burner
Head/Cap
Assembly
The burner heads and the oval burner
head/cap assembly ore removable.
Simply lift them off the range for cleaning.
For proper ignition, make sure the
small hole in the section that fits over the
electrode is kept open. A sewing needle
or wire twist-tie works well to unclog it.
Theslits in the burner heads must be kept
cleon at a!! times for an even,unhampered
flame.
Clogged or dirtg burner ports or electrodes
will not allow the burner to operate properly.
Ang spill on or around an electrode must
be carefullg cleaned. Take care to not hit an
electrode with anything hard or it could be
damaged.
Clean the burner heads routinelg, especiallg
after bad spillovers,which could clog the
openings. Lift off when cool.
To remove burned-on food, soak the burner
heads in a solution of mild liquid detergent
and hot water for 20-]0 minutes. For more
stubborn stains, use a toothbrush.
After cleaning
Before putting the burner caps, heads and
oval head/cap assemblg back, shake out
excess water and then drg them thoroughly
by setting in a warm oven for ]0 minutes.
Replacement
Burner Heads
Replaceburner heads over the electrodes
on the cooktop, in the correct locations
according to their size.There is one small,
one medium, one large and one extra large
burner head.
neaa
Hake sure me slot i n me burner neaa s
positioned over me electroae.
Oval (CenterJ Burner Head/Cap
Assembly
Replace m e ova icen_erl
head/cao assemDb
overtheelectrode on thecooktop,
Ovalhead and cad
Make suretheslot in
assernbg
theburnerhead is
positioned over the
L
J
electrode.
L.',J
,o
Front of range
Electrode
Caps
Replace the matching size caps onto the
burner bases or heads.
Large cap
_
.
_=_J
Extralarge
Front of range
cap
Hake sure that the heads and caps are
replaced in the correct locations.

Advertisement

Table of Contents
loading

Table of Contents