Craftsman Mow-N-Vac 486.24505 Owner's Manual page 12

• .Assemble ==door latch at each end of crom brace
using a 5/16" x 3/4" hex bolt, a nylon washer and a
5/16" hex lock nut. Place nylon washer between door
latch and cross brace, Tighten so that latch is snug
but will still rotate, See figure 18.
• -Assemble door support brackets undemeath the rear
of the cart bed by removing the hex nuts from the
bolts shown in figure 18, Fasten the brackets to the
cart using the same hex nuts which were removed.
5/16" HEX NYLON CROSS
LOCK NUT WASHER BRACE
'5/16" x 3/4"
HEX BOLT
BOLT
DOOR
SUPPORT
BRACKET
i
4----- HEX NUT
FIGURE 18
DOOR
LATCH
TIE
(SHORT
I/4" FLAT
1/4" x 1" WASHER
HEX BOLT 1/4"
HEX NUT I/4" LOCK-WASHER
FIGURE 19
Assemble the elbow to the blower housing, using two
5/16 =x 3/4" hex bolts, two large 1-1/2" nylon washers,
and two 1-1/2" flat steel washers. See figure 20.
Tighten hex bolts securely,
Assemble one short tie strap to each side of rear door
using one 1/4" x 1-1/4" hex bolt, two 1/4" fiat washers,
one 1/4" lock washer and one 1/4" hex nut, Assemble
an "S" hook through the loose end of each strap. See
figure 19.
Assemble a 1/4" x 1• hex bolt with a 1/4" hex nut to
outside of hole on each side of cart bed and secure
from inside with a 1/4" lock washer and a 1/4" hex
nut. See inset in figure 19.
Assemble door to rear of cart by resting bottom of
door on door support brackets and rotating top of door
forward to meet cross brace, Latch top of door on
each side. See figure 19.
Hook both the tie straps onto the 1/4" x 1" hex bolts
which were just assembled. See figure 19.
ELBOW
1-1_"O.D.
NYLON
WASHER
5/16" x 3/4"
HEX BOLT
BLOWER
HOUSING
FIGURE 20
12