Craftsman Mow-N-Vac 486.24505 Owner's Manual page 11

• Assemble front panel over the ends of the side panels
and on top of the cart bed flange and the comer caps.
Leaving the top holes in the front panel empty, fasten
it to the cart body and the side panels using six 1/4"
x 3/4 =hex bolts, six 1/4" flat washers, six 1/4" lock
washers and six 1/4" hex nuts. See figure 15.
1/4" FLAT
1/4" LOCK WASHER 1/4" x 3/4"
WASHER HEX BOLT
\
FRONT
PANEL
FIGURE 15
Assemble the cross brace to the two top holes at the
rear of each side panel using four 1/4" x 3/4" hex
bolts, four 1/4" lock washers and four 1/4" hex nuts.
See figure 16.
CROSS 1/4" x 3/4"
BRACE HEX BOLT
1/4"
Install the poly hard tbp over the front and side
panels. Fasten it to the panels using fourteen 1/4" x
3/4' hex bolts, 1/4' fiat washem, 1/4' lock washers
and 1/4" hex nuts. Seefigure 17.
Assemble four clamps onto the cart flanges, two on
each side of the cart, positioned approximately 12"
from each end. Fasten each clamp from the bottom
with a 3/8" x 1-1/2" hex bolt. See figure 17.
Assemble a clamp at center of front panel and cart
flange using a 3/8" x 1-1/2" hex bolt. See figure 17.
1/4" LOCK 1/4" HEX NUT POLY HARD TOP
WASHER
CLAMP
CLAMP
CENTER
FRONT
FIGURE 17
FIGURE 16
11