Drum/Wheel Assembly - Craftsman 113.179715 Owner's Manual

Assembly (continued)
Drum/Wheel Assembly
If any parts are missing or damaged
contact Sears Customer Service.
Do not assemble until you have all the
parts.
1. Insert rear wheel foot (left) and rear
wheel foot (right) into the bottom of
drum as shown. Check to make sure
axle holes align. Light taps with a
mallet or hammer may be needed to
fully seat both wheel feet. Insert two
front caster feet.
Front
Caster
Foot
Rear
Wheel
Foot
HOLES (Right)
ALmGN
Front
Caster
Foot
2. Install (4) #10 x 1-3/4" screws into
matching holes on both wheel feet and
front caster feet, securing them to the
bottom of the drum. Tighten screws
until just snug. Do not over tighten as
this may tend to deform the feet.
#10 x 1=3/4"
Screw (4)
3. Installing Cap Nut
a. Place cap nut on end of axle.
b. Tap gently with hammer until fully
seated.
c. Place wheel on the axle with
smooth portion of wheel facing
outward.
Rear Wheel Foot
(Right)\ Drain
O
End
Cap
Nut
Wheel
Foot (Left)
w/Wheel
NOTE: Smooth side of the
wheel to the outside.
4. Slide open end of axle through left rear
wheel foot hole. Slide all the way
through the hole in the right rear wheel
foot. Light taps with a mallet may be
required to fully insert axle.
5. Install second wheel onto axle with
smooth portion of wheel facing
outward.
6. Install the second cap nut. Tap gently
until cap nut is firmly seated
Wheel
Foot
Caster
Foot