Drum/Wheel Assembly - Craftsman 113.179715 Owner's Manual

Drum/Wheel Assembly
If any parts are missing or damaged
contact Sears Customer Service.
Do not assemble until you have all the
parts.
1. Insert rear wheel foot (left) and rear
wheel foot (right) into the bottom of
drum as shown. Check to make sure
axle holes align. Light taps with a mallet
or hammer may be needed to fully seat
both wheel feet. Insert two front caster
feet.
Rear Wheel /__----_
Foot (Left) _-_J Rear
Wheel
Drum AXLE
Foot
HOLES
(Right)
ALIGN
Front
Caster
Foot
Front
Caster
Foot
2. Install (4) #10 x 1-3/4" screws into
matching holes on both wheel feet and
front caster feet, securing them to the
bottom of the drum. Tighten screws until
just snug. Do not over tighten as this
may tend to deform the feet.
#10 x 1-3/4"
Screw (4)
' Caster
Wheel Foot
Foot
3. Installing Cap Nut
a. Place cap nut on end of axle.
b. Tap gently with hammer until fully
seated.
c. Place wheel on the axle with smooth
portion of wheel facing outward.
Rear Wheel Foot
Drain
/-
0
End
Cap
Nut
Wheel
Foot (Left)
w/Wheel
NOTE: Smooth side of the
wheel to the outside.
4. Slide open end of axle through left rear
wheel foot hole. Slide all the way
through the hole in the right rear wheel
foot. Light taps with a mallet may be
required to fully insert axle.
5. Install second wheel onto axle with
smooth portion of wheel facing outward.
6. Install the second cap nut. Tap gently
until cap nut is firmly seated
7. Using a rubber mallet or hammer, gently
tap the wheel cap onto the right wheel
until the wheel cap is firmly seated onto
the wheel. This is required on both left
and right sides.
Wheel
Cap