GE JGRP17 Owner's Manual page 11

USING YOUR OVEN
Before Using Your Oven
1. Look at the controls. Be sure you understand
how to set them properly.
2. Check the oven interior. Look at the shelves.
Take a practice run at removing and replacing
them properly to give sure, sturdy support.
3. Read over the information and tips that follow.
4. Keep this guide handy so you can refer to it,
especially during the first weeks of using your
new oven.
NOTE:
• You may notice a "burning" or "oily" smell the first
few times you turn your oven on. This is normal in
a new oven and will disappear in a short time. To
speed the process, set a self-clean cycle for 4 hours.
See the Operating the Self-Cleaning Oven section.
• A cooling fan may automatically turn on and •fit•
cool internal parts. This is normal, and the fan may
continue to run even after the oven is turned off.
Automatic Ignition
The oven burner is lit by electric ignition.
To light the burner, press the pad for the desired
function and press the TEMP + or - pads until the
desired temperature is displayed. The burner should
ignite within 60 seconds.
Aider the oven reaches the selected temperature, the
oven burner cycles offcompletely, then on with a full
flame to keep the oven temperature controlled.
Oven Vent
When the oven is on, heated air moves through a vent
behind the grille. See the Features of Your Oven section.
The vent area could get hot during oven use.
The vent is needed for proper air flow in the oven and
good baking results. Do not block this vent. Doing so
may cause oven failure or fire.
Power Outage
The oven burner will not light in the event of an electrical power outage.
Do not attempt to light it manually with a match.
Oven Shelves
The shelves are designed with stop-locks so that,
when placed correctly on the shelf supports they
will stop before coming completely out of the oven
and will not tilt when you are removing food from
them or placing food on them.
When placing cookware on a shelf, pull the shelf out
to the bump on the shelf support. Place the cookware
on the shelf, then slide the shelf back into the oven.
This will eliminate reaching into the hot oven.
To remove a shelf
from the oven, pull
the shelf toward you,
tilt the front end
upward and pull the
shelf out.
Bump
To replace, place
the shelf on the shelf
support with the stop-
locks (curved
extension of the shelf) facing up and toward the
rear of the oven. Tilt up the front and push the shelf
toward the back of the oven until it goes past the
bump on the shelf support. Then lower the front of
the shelf and push it all the way back.
(continued next page)
11
I,i• I
_'/'II
Ol