Semi-Automatic Head; Throttle Handle; T Throttle Handle - Craftsman 358.798470 Operator's Manual

ASSEMBLY
SEMI-AUTOMATIC HEAD ASSEMBLY (Fig. 4)
• Ensure the plasticdebrisshield is in place and secured.
• Install dust cup over the arbor shaft.
• Align the hole in the dust cup with the hole in the cen-
ter front of the gear box by turning the dust cup.
• Install the grass washer over the arbor shaft. Make sure
the grass washer is against and curved over the dust cup.
• Start threading the semi-automatic head onto the arbor
shaft (counterclockwise).
• Insert the short hex key (provided) into the aligned
holes to keep the arbor shaft from turning.
• Tighten the semi-automatic head while holding the
short hex key.
• Remove the short hex key.
GEARBOX
WIDEST PART
OF SHIELD
THROTTLE HANDLE ASSEMBLY (Fig. 5 & 6)
• Remove the screw from the throttle handle.
• Slide the throttle handle onto the right side of the han-
dlebar and align the screw hole.
• Placing the engine on your right side, with the shaft of
the unit extending to the front, the throttle handle
should be in your right hand,
IMPORTANT: REFER TO THE ILLUSTRATION ON THE
FRONT COVER FOR PROPER POSITION. MAKE
SURE THE ENGINE SWITCH IS LOCATED ON THE
TOP OF THE HANDLEBAR.
• Insert screw and tighten with hex key.
ENGINE SWITCH THROT'rLE
SCREW
THROTTLE
THRO'FrLE TRIGGER
Figure 5
• After attaching the throttle handle assembly and han-
dlebar to the unit, rout the cable harness assembly
through the slit in the bottom of the foam grip.
FOAM
GRIP
ABLE HARNESS AND
HANDLE ASSEMBLY
Figure 6
-9-