ml
i
iiii
i
SERVICE AND ADJUSTMENTS
•
i
ii
• Wrap rope counterclockwise around the pulley ratchet
and tuck loose end under rope where it comes out of
the pulleyhole. Leave a 1-inch tail laying flat on top of
the pulley between the retainer rib and the rope reten-
tionscrew/post.
• Reinstall the rope retention screw into the retention
post.Tightenuntil snug.
NOTE: Do not overtighten the screw. Overtighteningthe
screw can cause the threads in the screw post to strip
out.
• Hold rope taut at rope exit hole so il wig not move and
remove long hex wrench.
• Slowly feed rope into the pulley housing.
• Make sure spacer is in place then reverse steps to
reassemble.
Figure 33
- 25 -