Table of Contents
Advertisement
Clean
Guard/Muffler
Do not clean with a forceful spray of water because
water could contaminate
fuel system.
With a brush or
cloth clean finger guard after every use to prevent
engine damage caused by overheating. Before running
engine, clean muffler area to remove all combustible
debris.
CLEAN
Clean and Replace
Spark Plug
Check spark plug yearly or every 100 operating hours.
•
Clean area around spark plug.
•
Remove and inspect spark plug.
•
Replace spark plug if electrodes are pitted, burned
or porcelain is cracked.
For replacement
use
Champion RJ 17LM resistor spark plug.
•
Check electrode gap with wire feeler gauge and
set gap .030 if necessary.
•
Install spark, tighten securely.
.030" (0.76MM)
WIRE GAUGE
SPARKPLUG
CLEAN
CARBURETOR
The carburetor of your generator is pre-set at the fac-
tory. The carburetor should not be tampered with. If your
generator is used at an altitude in excess of 4000 feet
performance
may be affected.
If so consult with your
nearest Craftsman Service Center regarding high altitude
set changes.
GOVERNOR
Your engine governor maintains the constant operating
speed of your generator. DO NOT tamper with the en-
gine governor
which is factory
set for proper engine
speed.
Over-speeding your engine above factory high speed set-
ting can be dangerous and could possibly cause per-
sonal injury or property damage. If you believe the en-
gine is running too fast or slow, take your generator to a
Authorized Craftsman Service Center for repair and ad-
justment.
I
Low engine speeds impose a I
heavy load on the engine and I
when sufficient
power is not available the engine
fe cou d be shortened.
MGP-679501
16 -- ENG
Advertisement
Table of Contents
