Craftsman 917.297031 Owner's Manual page 11

TO START ENGINE
_CAUTION: Keep drive control bar in
"DISENGAGED" position when starting
engine.
When starting engine for the first time or if
engine has run out of fuel, it will take extra
pulls of the recoil starter to move fuel from
the tank to the engine.
1, Make sure spark plug wire is properly
connecte&
2_ Move shift lever indicator to "N" (neu-
tral) position,
3, Place throttle control in "FAST" posi-
tion_
4, Turn fuel shut-off valve 1/4 turn to open
position,
5, Move choke control to choke position.
6, Grasp recoil starter handle with one
hand and grasp tiller handle with other
hand. Pull rope out slowly until engine
reaches start of compression cycle
(rope will pull slightly harder at this
point),
7. Pull recoil starter handle quickly, Do
not let starter handle snap back
against starter,
NOTE; if engine fires but does not start,
move choke control to half choke posi-
tion, Pull recoil starter handle until engine
starts.
8, When engine starts, slowly move
choke control to "RUN" position as
engine warms up.
NOTE: A warm engine requires less
choking to start,
9. Move throttle control to desired running
position,
10, Allow engine to warm up for a few
minutes before engaging tines,
NOTE: If at a high aJt_"tude (3000 feet) or
in cold temperatures (below 32°F), the
carburetor fuel mixture may need to be
adjusted for best engine performance,
See "TO ADJUST CARBURETOR" in the
Service and Adjustments section of this
manual.
NOTE: If engine does not start, see trou-
bleshooting points,
TILLING HINTS
_IbCAUTION: Until you are accustomed
to handling your tiller, start actual field
use with throttle in slow position (mid-way
between "FAST" and "IDLE").
• Tilling is digging into, turning over, and
breaking up packed soil before plant-
ing_ Loose, unpacked soil helps root
growth. Best tilling depth is 4" to 6". A
tiller will also clear the soil of unwanted
vegetation_ The decomposition of this
vegetable matter enriches the soil.
Depending on the climate (rainfall and
wind), it may be advisable to till the soil
at the end of the growing season to
further condition the soil
• Soil conditions are important for proper
titling. Tines will not readily penetrate
dry, hard soil which may contribute to
excessive bounce and difficult handling
of your tiller_ Hard soil should be mois-
tened before tilling; however, extremely
wet soil will "ball-up" or clump during titl-
ing. Wait until the soil is less wet in order
to achieve the best results. When tilling
in the fall, remove vines and long grass
to prevent them from wrapping around
the tine shaft and slowing your tilling
operation.
• You will find tilling much easier if you
leave a row untilled between passes°
Then go back between tilled rows.There
are two reasons for doing this. First,
wide turns are much easier to negoti-
ate than about-faces. Second, the tiller
won't be pulling itself, and you, toward
the row next to it.
• Do not lean on handle. This takes
weight off the wheels and reduces
traction° To get through a really tough
section of sod or hard ground, apply
upward pressure on handle or Iower the
depth stake.
Fuel Shut-Off
Rewind Starter
Choke Control
11