Advertisement
Cleaning
the Contoured
Well Areas,
Burner
Cap, Burner
Head and Burner
Drip Pans (some
models)
The contoured well areas, burner cap, burner head and burner drip pans (some models) should be routinely cleaned.
Keeping the burner ports clean will prevent improper ignition and an uneven flame. Refer to the following instructions:
Surface
Burner
TO Clean the Recessed and Contoured
Areas of the Cooktop
- If a spill
Grate
occurs on or in the recessed or contoured areas, blot up spill with an absorbent
cloth. Rinse with a clean, damp cloth and wipe dry.
Surface
Burner
Cap
Surface
Burner
Head
To Remove and Replace the Surface Burner Caps and Surface
Burner
Heads - Remove in the following order: (1 st) surface burner grate, (2nd)
surface burner cap, (3rd) surface burner head and (4th) surface burner drip pan
(if equipped).
Reverse the procedure above to replace the surface burner cap, surface burner
head and surface burner drip pans (if equipped). Do not remove any parts
from the cooktop
until they have completely
cooled and are safe to
handle, Do not operate the surface
burners
without
the surface burner
cap and surface
burner head properly in place.
/Orifice
i
i
Removable
Burner
Drip Pan
(on some models)
Note: The burner grate style shown
above may be a different depending
on your model.
To Clean the Surface Burner Cap, Surface
Burner Head and Surface
Burner Drip Pan (if equipped) =Use a soap-filled scouring pad or a mild
abrasive cleanser to clean the surface burner caps, surface burner heads and
surface burner drip pans (if equipped). The ports (or slots) around the burner
head must be routinely cleaned. If residue still remains in these ports, use a
small-gauge wire or needle to clean the slots or holes. For proper flow of gas
and ignitionof the burner--DO
NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTH ER MATERIAL TO ENTER TH E GAS ORIFICE
HOLDER OPENING. ALWAYS keep the surface burner cap and surface burner
head in place whenever a surface burner is in use.
AdjustingYourOvenTemperature
Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe
times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times,
you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.
To Adjust
Oven Temperature:
1.
Press _.
2.
Set the temperature to 550°F (287°C) by pressing and holding the ,_.
3.
Within 2 seconds, press and hold (_
until the 2 digit display appears. Release(_.
The display now indicates the amount
of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control
has the original factory calibration, the display will read "0."
4.
Thetemperat_recann_wbeadjustedup_rd_wn35°F(17°c)_in5°Fstepsbypressingandh__dingthe
,1_ or V.
Adjust
until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-) will appear
before the number to indicate that the oven will be cooler by the displayed amount of degrees.
5.
When you have made the desired adjustment, press @
to go back to the time of day display.
Note: Oven temperature adjustments made wi!l not change the Self, Cleaning feature temperaturei
18
Advertisement
