Dark Background Density - Oki OKIPAGE 4M Maintenance Manual

2

Dark background density

• Has the OPC drum being exposed to external light?
• Yes
• No Is the heat roller of the heat assy dirty?
• Yes
• No Is the terminal of the EP unit in correct contact with the contact plate? (See Figure
6-4
• No
• Yes Replace the EP unit.
• Has this error been recovered?
• Yes
• No Replace the main control board or high-voltage power supply board.
3
A blank paper is output.
• Is the LED head connected correctly. (Check the CN6 connector of the main control board.)
• No
• Yes Is the terminal of the EP unit in correct contact with the contact plate? (See Figure
6-5
• No
• Yes Replace the LED head.
• Has this error been recovered?
• Yes
• No Replace the main control board or high-voltage power supply board.
Set the OPC drum in the OKIPAGE 4w Plus/4m and wait for about 30 min-
utes.
Clean the heat roller.
and Figure 6-5 .)
D D
Contact the terminal correctly.
End
Caution: After replacing the EP unit, reset the drum counter. (Refer to
"Replacing the Drum Cartridge" in "User's Manual".)
Connect the LED head correctly.
.)
E
Contact the terminal correctly.
End
Caution: Set the LED head drive time when replacing the LED head. (See
Section 4.2.1.)
6 - 15