Frigidaire FRA08PZU110 Use & Care Manual page 10

Operating Instructions
(continued)
TO CHANGE TEMPERATURE DISPLAY; YOU WILL SEE:
remote
sensing
V
temp/timer
auto l
hi , fitter
reed
to reset
m
0N-0FF A FAN SPEED steep
\ /DO THIS:
PRESS AND HOLD THE
UP/DOWN BUTTONS
TOGETHER FOR 3 SECONDS
remote
sensing
temp/timer
c _
auto J
hi ,
fitter
med
lo reset
V 0N-0FF A FAN SPEED sleep
Note: The control is capable of displaying temperature in
degrees Fahrenheit or degrees Celsius.
TO TURN UNIT OFF: YOU WILL SEE:
remote
sensing
temp/timer
auto j!
hi . I fitter
med
/
Zo reset
m
V ON-OFF A FAN SPEED steep
_ DOTHIS:
i
PRESS
ON/OFF BUTTON
temp/timer auto i
remote _ _ hi
fitter
sensing med
to
reset
V ON-OFF A FAN SPEED steep
ADDITIONAL THINGS YOU SHOULD KNOW
Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with.
• The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly.
This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue
to run during this time.
• There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY/HEAT. This is to cover the possibility of
having to roll through to select another mode.
• The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees in cool mode, 55F
and 80F degrees in heat mode(the upper limit of temperature could reach 86F degrees on some of the 115V models).
• After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.
Fresh Air Vent Control (on some models)
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air - Vent Closed (see Fig. 1)
2. Draw fresh air into the room - Fresh Air (see Fig. 2)
3. Exchange air from the room - Vent Open (see Fig. 3)
Figure 1 (VENT CLOSED)
, I i_ i
Figure 2 (FRESH AIR)
10
Figure 3 (VENT OPEN)
©2009 Electrolux Home Products, Inc. All rights reserved.