For SLO3 Air Conditoner (8,000~12,000 BTU)
Carefully read the installation manual before beginning.
Follow each step as shown.
Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.
Pay attention to danger and safety notices.
To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may
be exposed:
Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install
the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To
prevent injury or strain, use proper lifting and carrying techniques when moving unit.
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended
period of time.
Handle air conditioner with care.
Make sure air conditioner does not fall during installation.
Tools and Parts:
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools
listed here.
Flat-blade and Phillips screwdrivers
Level
Through-the-wall Installation:
In addition to the tools listed above, the following tools are needed for through-the-wall installation.
saw
Parts Supplied:
Check that all parts are included in parts package:
Hardware
screws
Installation Instructions
READ BEFORE INSTALLING UNIT
INSTALLATION WARNINGS AND CAUTION
TOOLS NEEDED
caulk
pan - head
Phillips screws
round - head
pan - head
Phillips screws
side curtains
TOOLS NEEDED
Tape measure
Qty.
3
2
,
Hardware
Top channel
Window sash seal
Foam seal
window lock bracket
Safety Lock
(for Vinyl-Clad window)
weather seals
Qty.
1
1
1
1
2
1