Care And Cleaning - Frigidaire FRS23ZTJB0 Use & Care Manual

Care and Cmeaning
Keep your refrigerator and freezer clean to prevent odor build-up. Wipe up any spills
im med lately and clean both sections at least twice a year, Never use meta Ilicscouring
pads, brushes, abrasive cleaners or strong alkaline solutions on any surface, Do not
wash any removable parts in a dishwasher,
Always unplug the power cord from the wall outlet before cleaning.
NOTE: Turning the control to OFFdoes not disconnect )ower to the controls, light bulb,
or other electrical components,
Damp objects stick to cold
metal surfaces, Do not touch refrigerated
surfaces with wet or damp hands,
_To avoid damage and help
the refrigerator run as efficiently as
possible, clean the condenser and air
versts periodically,
Inside
Wash inside surfaces of the refrigerator and freezer with a solution of 2 tablespoons
baking soda in 1 quart warm water, Rinse and dry thoroughly, Be sure to wring
excess water out of sponge or cloth before cleaning around the controls, light
bulb, or any electrical parts.
Wash removable parts such asshelves and drawers with baking soda solution or mild
detergent and warm water Do Not Use Harsh Cleaners On These Surfaces Rinse
and dry thoroughly. Clean the door gaskets with mild suds, rinse with clear water and
wipe dry, Do not use razor blades or other sharp instruments which can scratch the
appliance surface when removing adhesive labels, Any glue left from the tape or
energy label can be removed with a mixture of warm water and mild detergent, or,
touch the glue with the sticky side of tape already removed, Do Not Remove The
Serial Plate,
Outside
Wash the cabinet and handles with warm water and mild liquid detergent, Rinsewell
and wipe dry with a clean soft cloth, Do not use commercial household cleaners,
ammonia, or alcohol to clean handles,
Air Vents on Lower Access Panel
LIGH[ SHIELD
\
\
\
\
\
UP
TO REMOVE
Removing Crisper Light Shield and Bulb
(some models)
Remove any dust or dirt from the front of the toe grill using a vacuum cleaner with
its dusting tool attachment. Remove the toe grill by pulling it straight out. While the
grill is removed, vacuum the backside of the grill and wipe with a sudsy cloth or
sponge. Periodically clears the condenser (black tubes and wires berseath the
refrigerator, behind the toe grill). Do not allow lint or dust to accumulate orsthe coils.
Insert a long handled brush or vacuum attachment between the two coils to bring the
lint forward. To replace the toe grill, line up tabs with holes and push grill straight ors.
Use caution when cleaning in the area of the coils, Surfaces there
may be sharp,
The air vents on the lower accesspanel atthe rear of the refrigerator should becleaned
periodically, Clears the versts by using a vacuum cleaner with its dusting tool
attachment, When moving the refrigerator, pull straight out, Do not shift the
refrigerator from side to side as this may tear or gouge the floor covering, Be careful
not to move the refrigerator beyond plumbing connections,
Replacing the Light BuLb
To replace the light bulb in either compartment:
1. Unplug the refrigerator.
2. Wear gloves as protectiors against possible brokers glass.
3. Replace old bulb with an appliance bulb of the same wattage,
4. Remember to plug the refrigerator back in.
Vacation and Moving Tips
Short vacations:
o Leave refrigerator operating during vacations of 3 weeks or less.
• Use up all perishable items in refrigerator section.
• Wrap and store other items in the freezer.
• Turn off automatic ice maker, even if you will be gone just a few days.
11