Advertisement
WARNING:
Your drill should never be
am,
connected to power supply when you are
assembling parts, making adjustments, installing
or removing ddll bits, cleaning, or when not in
use. Disconnecting your drill will prevent
accidental starting that could cause sedous
personal injury.
SWITCH
See Figure 2.
To turn your hammer ddll ON, depress the switch
tdgger. Release switch trigger to turn your hammer
drill OFF.
SWITCH
LOCK-ON
TRIGGER
Fig. 2
LOCK-ON
BUTTON
See Figure 2.
Your hammer ddll is equipped with a lock-on feature,
which is convenient when continuous drilling for
extended pedods of time is required. To lock-on,
depress the switch trigger, push in and hold the lock-
on button located on the side of the handle, then
release switch trigger. Release lock-on button and
your drill will continue running.
To release the lock, depress the switch trigger and
release.
If you have the lock-on feature engaged dudng use
and your drill becomes disconnected from power
supply, disengage the lock-on feature immediately.
_lb WARNING:
Before connecting your ddll to
power supply source, always check to be sure it
is not in lock-on position (depress and release
switch trigger). Failure to do so could result in
accidental starting of your ddll resulting in
possible sedous injury. Also, do not lock the
tdgger on jobs where your drill may need to be
stopped suddenly.
REVERSIBLE
See Figure 3,
Your hammer ddll has the feature of being reversible.
The direction of chuck rotation is controlled by a lever
located above the switch trigger. With your ddll held in
normal operating position, the direction of rotation lever
should be positioned to the left of the switch for
forward ddlling operation. The direction of rotation is in
reverse when the lever is to the right of the switch.
The design of the switch will not permit changing the
direction of rotation while the ddll is running. Release
the switch tdgger and allow the drillto stop before
changing its direction.
Note: Your hammer ddll will not run unless the switch
lever is pushed fully to the left or dght.
REVERSE(R)
FORWARD(_
FORWARD
REVERSELEVER
Fig. 3
8
Advertisement
