•
Remove adjusting keys or wrenches
before
turning the tool on. A wrench or a key that is left
attached to a rotating part of the tool may result
in personal injury.
•
Do not overreach.
Keep proper footing
end
balance at ell tlmee. Proper footing and balance
enables better control of the tool in unexpected
situations.
•
Use safety equipment. Always wear eye
protection. Dust mask, nonskid safety shoes,
hard hat, or hearing protection must be used for
appropriate conditions.
Tool Use and Care
•
Use clamps or other practlcel way to secure
end support the workplece to a stable plat-
form. Holding the work by hand or against your
body is unstable and may lead to loss of control.
•
Do not force tool. Use the correct tool for
your application.
The correct tool will do the job
better and safer at the rate for which it is de-
signed.
•
Do not usa tool if switch does not turn It on or
(_)ff.Any tool that cannot be Controlled with the
S_'itch is dangerous and must be repaired.
•
Disconnect the plug from the power source
before meldng any edJuatments, changing
accessories,
or atorlng
the tool. Such preven-
tive safety measures redUce risk of starting the
tool accidentally.
•
Store Idle tools out of reach of children end
other untrained persons.
Tools are dangerous
in the hands of untrained users.
•
Maintain tools with care. Keep cuffing tools
sharp and clean. Pmpedy maintained tools, with :
sharp cutting edges are less likely to bind and are
easier to control.
•
Check for mlsallgnment
or binding of moving
parts, breakage of parts, and any other oondi-
tion that may affect the tools operstlon. If
damaged, have the tool serviced before using.
Many accidents are caused by poorly maintained
tools.
•
Use only accessodes
that are recommended
by the manufacturer
for your model. Accesso-
des that may be suitable for one tool, may be-
come hazardous when used on another tool.
SERVICE
•
Tool service must be performed
only by
qualified repair personnel.
Service or mainte-
nance performed by unqualified personnel could
result in a risk of injury.
•
When servicing • tool, usa only Identical
replacement
parts. Follow Inatructlons
In
Maintenance
section of this manual. Use of
unauthodzed parts or failure to follow Mainte-
nance Instructions may create a risk of electric
shock or injury.
3