Fuel Filter - Craftsman 358.352161 Operator's Manual

CUSTOMER RESPONSIBILITIES
REPLACE FUEL FILTER (Fig. 33, 34 & 35)
The fuel filter should be replaced after each season. Never
operate your saw without a fuel filter. Be careful not to
damage fuel line while removing the fuel filter.
Run fuel tank dry of fuel before proceeding with this step.
Remove fuel cap and allow it to hang to side'of motor.
Using a small pair of needle nose pliers, grasp fuel cap
retainer, holding it in tank opening and pul! out.
With cap out of tank, use a small section of bent wire
similar to that shoWn in the illustration to catch fuel line
and slowly pull from tank:When fuel filter appears in
opening, grasp with fingers and remove from tank.
Once filter is out of tank, hold fuel line close to fuel filter.
Remove fuel filter by twisting and pulling at the same
time.
Replace fuel filter.
Reverse process for installation.
Fuel Cap
Fill Cap
Pliers
Figure 33
Figure 34
Fuel Line
!
Fuel Filter
Barrel
Filter Neck "_ _)
......
Fuel Filter
Figure 35
-21 -