Adjustment Instructions; Install Power Cord Brackets; Adjusting The 90 Table Stop; Table Adjustments - Craftsman 137.224240 Operator's Manual

iNSTALL POWER CORD BRACKETS ( Fig,L)
1. Power c ordbrackets (1)areprovidect forconvenient
cordstorage. Atlachthepower c ordbrackets t otheback
ofthesawbocty, asshown, w ithtwoPhillips head
screws (2).Tighten.
2. Wrapthepower c ordontothebrackets w hentheband
saw
is not ill
use, to prevent damage to the cord.
Fig. L
ADJUSTMENT gNSTRUCT ONS
To avoid injury, turn the switch OFF and unplug the barld saw
from the power source before making any adjustments.
TABLE ADJUSTMENTS (Fig. M, N)
Tilting the table (F_g. IBm) i
The band saw table (1) tills 0° an@to 45 ° right
1. Loosen both table lock knobs (2) undemeath:the table.
2. Tilt the table to the desired angle on the scale (3)
underneath the table.
3. Tighten the two table lock knobs.
ADJUSTING THE 90 ° TABLE STOP (Fig. N)
1. Loosen the table lock knobs (2) and tilt the table to
the right.
2. Loosen the nut (4) on the table stop bolt (5) and lower
the stop bolt as far as possible.
3. Tilt the table until it rests on the stop bolt.
4.. Place a combination square (6) on the table with the
heel of the square against the saw blade.
5. Adjust the tilt of the table left or right until it is 90 ° to the
blade. Make sure there is no space between the square
and the blade.Tighten the table lock knobs.
6. Adjust the table stop bolt up until it touches the table.
Tighten the jarn nut down to the support bracket,
7. Loosen the lock knobsand see that the table is resting
on the stop bolt.
8. Check the scluare to make sure the table is still square to
the blade. If not, readjust the stop bolt.
9. When the adjustment is accurate at 90 °, align the
pointer (7) to 0° on the scale (8).
2 4
Make sure the blade is in center of table insert slot(2)
Then tighten the screw(A-C) which are under the table on
both sides as shown (Fig O.)
Fig. O
_, 13