Craftsman 320.27990 Operator's Manual page 12

SELECTING THE CORRECT SOCKET (SOCKETS AVAILABLE SEPARATELY)
_, CAUTION: Always verify that the tool is switched off and unplugged before
installing any accessories on the tool.
Always use the correct size socket for bolts and nuts. An incorrect socket will
result in inaccurate and inconsistent fastening torque and/or damage to the bolt
or nut.
INSTALLING AND REMOVING THE SOCKET (Fig. 2)
1. To install the socket, push it onto the
output drive of the tool until it locks into
place.
2. To remove the socket, simply pull it off.
TURNING THE IMPACT WRENCH ON (Fig, 3)
1.
Fig. 2 _r_------_j /
Socket
Output
Drive
Connect the power cord of your impact
wrench to a standard household power
outlet.
Fig. 3
2. Press the part of the switch marked _F_,
to run the tool in the forward direction
(clockwise rotation). Use this direction for
tightening bolts or nuts.
Switch
3. Press the part of the switch marked _-R_
to reverse the motor direction (counter-
clockwise rotation). Use this direction for
loosening bolts or nuts.
4. Release the switch to stop the tool.
5. Keep the switch pressed for continuous operation.
_, CAUTION: Do not allow familiarity with your impact wrench to make you
careless. Remember that a careless fraction of a second is sufficient to cause
severe injury.
27990 ManuaLRevised_lO ±202 Page 12