Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
ENGINE
TO REPLACE
HEADLIGHT
BULB
•
Raise hood.
•
Pullbulbholderoutoftheholeinthebacksideofthegrill,
•
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill,
•
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
•
Checkwiring. See electrical widng diagram inthe Repair
Parts section.
TO REPLACE
FUSE
Replace with 15 amp automotive-type plug-in fuse. The fuse
holder is located behind the dash,
TO REMOVE
HOOD AND GRILL ASSEMBLY
(See Fig. 27)
•
Raise hood.
•
Unsnap headlight wire connector.
•
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
•
To replace, reverse above procedure.
_
HOOD
i
_-_,
HEADDGHT
I
/
_1
WIRE
/
/
\
7
CONNECTOR
"
/
/
,{
7
FIG. 27
Maintenance, repair, or replacement of the emission control
devices and systems, which are being done at the custom-
ers expense, may be performed by any non-road engine
repair establishment or individual.Warranty repairs must be
performed by an authorized engine manufacturer's service
outlet.
TO ADJUST
THROTTLE
CONTROL
CABLE
(See Fig. 28)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as follows:
•
With engine not running, move throttle control lever to
fast position.
•
Check that swivel is against side of quarter circle. If it
is not, loosen cable clamp screw and pull cable back
until swivel is against quarter circle.
Tighten cable
clamp screw securely.
CLAMP SCREW_
QUARTER
_
\
\
/
CIRCLE_
_
/
_
_
SWIVEL
FIG. 28
TO ADJUST
CHOKE CONTROL
(See Fig. 29)
The choke control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable• If adjustment is
necessary, proceed as follows:
•
With engine not running, movechoke control(locatedon
dash panel) to full choke position.
•
Remove air cleaner cover, filter and cartridge plate to
expose carburetor choke (see "AIR FILTER" in the
Customer Responsibilities section of this manual).
•
Choke should be closed. If itisnot, loosen casing clamp
screw and move choke cable until choke is completely
closed. Tighten casing clamp screw securely.
•
Reassemble air cleaner.
22
Hide quick links:
Advertisement
Table of Contents
