Table of Contents
Advertisement
Available languages
Available languages
Before
you
for service
N761
:Check that the cold water supply has been turned on.
Your cold water temperature
may exceed the recommended
limits (refer to
:: Installation
instructions
pages 6 - 11).
Checkthat
the inlet hose filter is not blocked.
Check that the inlet hose filte r is no t kinked or squashed.
..................................................
Check that the inlet hoses have been connected
to the correct faucets.
The flow rate of the supply water may be too slow.
"l_
O:V:E @LO _ DED"
::i::i::i::i::i::i
:
Your washer is overloaded
and cannot continu e the cycle.
...........
:: Ensure the washer is stationary
and remove items until the remaining
ones can
: move freely.
Check that the washer is not siphoning (refer to installation
instructions
pages 6 - 11).
Your washer has a suds build-up. Too much detergent
may have been used for the
amount of soft in the load.
Wait for suds to dissolve (about 20 minutes).
Rinse clothing
using the RINSE and SPiN cycle, or run through
another cycle.
Checkthat
the lid is closed.
Press START/PAUSE
Center.
Single beep every second and ...
3.
Check your washer is level (refer to installation
instructions
pages 6 - 11).
4.
Remove load and retry.
5.
Put through
a RINSE and SPIN cycle.
6.
if the fault re-occurs repeat steps 1 and 2.
if the washer still will not work, call your Fisher& Paykel Dealer or Authorized Service Agent to
arrange service (refer to page 45).
Advertisement
Table of Contents
