Download Print this page

Craftsman WEEDWACKER 358.791170 Operator's Manual page 12

33cc/2.0 cu.in. 2-cycle gasoline weedwacker

Advertisement

Available languages

Available languages

KNOW YOUR TRIMMER
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with the location
of the various controls and adjustments.
Save this manual for future reference.
Assist Handle
_,_
=_'
Coupler
_,__
Trimmer
'_
Head
Sha_
..... _
-
2N/STOP _
,
__u_'_
Primer Bulb
Starter Handle
J
Muffler
Line Limiter
Blade
/
Throttle Trigger
J
Start Lever
ON/STOP
SWITCH
The ON/STOP switch is located on the
trigger handle and is used to stop the
engine. To stop the engine, push and
release the engine ON/STOP switch.
PRIMER BULB
The PRIMER BULB removes air from
the carburetor
and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing it and allowing it to return
to its original form.
START LEVER
The START LEVER helps to supply fuel
to the engine to aid in starting. Acti-
vate the starting system by moving the
start lever to the START position. DO
NOT squeeze
the throttle trigger until
the engine has started and runs. After
the engine starts, allow the engine to
warm-up
5 seconds,
then fully
squeeze
the throttle trigger to deacti-
vate the starting system (start lever
returns to RUN position).
COUPLER
The COUPLER enables optional
at-
tachments
to be installed on the unit.
BEFORE
STARTING
ENGINE
_WARNIN_I:
Be sureto
read
the fuel information
in the safety rules
before you begin. If you do not under-
stand the safety rules, do not attempt
to fuel your unit. Call 1-800-235-5878.
FUELING
ENGINE
_LWARNING:
Remove fuel cap
slowly when refueling.
This engine is certified to operate on
unleaded gasoline. Before operation,
gasoline must be mixed with a good
quality synthetic 2-cycle air-cooled
engine oil. We recommend
Craftsman
brand synthetic oil. Mix gasoline and oil
at a ratio of 40:1. A 40:1 ratio is ob-
tained by mixing 3.2 ounces of oil with 1
gallon of unleaded gasoline. Included
with this trimmer is a 3.2 ounce contain-
er of oil. Pour the entire contents of this
container into 1 gallon of gasoline to
achieve the proper fuel mixture. DO
NOT USE automotive
oil or marine oil.
These oils will cause engine damage.
When mixing fuel, follow instructions
printed on container.
Once oil is added to gasoline,
shake
container
momentarily
to assure that
the fuel is thoroughly
mixed. Always
read and follow the safety rules relat-
ing to fuel before fueling your unit.
12

Advertisement

loading