Craftsman NEXTEC 320.30565 Operator's Manual page 14

Due to Lithium-Ion fade-free properties, the only time it is necessary to charge
the Lithium- Ion battery pack is when the pack has reached the end of its
charge. To signal the end of charge, power to the tool will drop quickly and the
FuelGauge LED will flash rapidly. Charge the battery pack as needed.
TO ATTACH BATTERY PACK (Fig. 2)
1. Make sure that the drill/
driver is "OFF".
2.
Align the raised ribs on
the battery pack with the
grooves of the drill/driver,
and then attach the battery
pack to the drill/driver.
NOTICE: Make sure that the
latch on the battery pack snaps
into place and the battery pack
is secured to the tool before be-
ginning operation.
TO DETACH BATTERY
PACK (Fig. 2)
Fig. 2
1. Lock the trigger switch on the drill/driver by placing the direction of rotation
(forward/center lock/reverse) selector in
center position.
2. Depress the battery release buttons located on the both sides of the battery
pack to release the battery pack.
3. Pull the battery pack out and remove it from the tool.
_, CAUTION: When placing the battery pack in the tool, be sure that the
raised ribs on the battery pack align with the grooves inside the drill/driver and
the latches snap into place properly. Improper assembly of the battery pack can
cause damage to internal components.
Fig. 3
_, WARNING: Battery
tools are always in operating
condition. Therefore, the
direction-of-rotation selector
should always be locked when
not in use or carrying the tool at
your side.
Forward Reverse
TRIGGER SWITCH (Fig. 3)
To turn the drill/driver ON, de-
press the trigger switch. To turn it trigger switch
OFF, release the trigger switch.
Direction-
of-rotation
selector
30565 Manual_Revised_11-0616 Page 14