Customer Responsibilities - Craftsman 919.152145 Owner's Manual

pressure c auses a hazardous
risk of bursting, Check the
manufacturer's maximum pressure
rating for air too{s and accessories,
The regumator outmet pressure
must never exceed the maximum
pressure rating,
How to Start:
1, Set the QWOff switch to ON O)
and allow tank pressure to build.
Motor will stop when tank pressure
reaches "cut-out" pressure.
2. Pull the regulator knob out
and turn clockwise to increase
pressure. When the desired
pressure is reached push knob in
to lock in place.
The compressor is ready for use.
iiiiii_ .... : iiiiil ....
Customer Responsibilities
3heck Safety Valve
:>rainTank
Before Daily
each or after
each
use
use
O
O
To Check Safety VaJve
power is on. When performing
maintenance, you may be exposed
to voltage sources, compressed air,
or moving parts. PersonaB injuries
can occur. Before performing any
maintenance or repair, disconnect
power source from the compressor
and bmeed off aH air pressure.
NOTE: See "Operation" section for
the location of controls.
propermy, over-pressurization may
occur, causing air tank rupture or
an expmosion.
1. Before starting compressor, pull
the ring on the safety valve to
make sure that the safety valve
operates freely. If the valve
is stuck or does not operate
smoothly, it must be replaced
with the same type of valve.
A10282 14 - ENG