Eureka 178A Owner's Manual page 6

Attach Charger Plug to Wall Bracket
CAUTION: Use only charger model AD-0920-UOE/EK for 120 volt.
Your vacuum cleaner has a special bracket designed to hold the unit, so that it may
recharge while mounted on the wall.
How to Mount your Vacuum Cleaner
Cleaner hangs in bracket with the nozzle end up. Mount on a wall where there are no
dangerous objects hidden beneath the wall surface like electrical wires, pipes, etc.
1. Hold bracket against wall to mark location for screws. Make sure the wall bracket is
positioned vertically, with the charger socket at the bottom. See Fig. 1.
2. Use a 1/4 inch drill for drilling holes for the plastic anchors.
3. Insert the anchors and drive the screws into both holes.
4. Coil up any extra cord length and place on the back of the bracket as shown in Fig. 2.
5. Tighten the screws to secure the bracket.
6. Place cleaner, with the nozzle pointed up, on the wall bracket, Fig. 3.
7. Plug the charger into an electrical outlet.
Charger
Socket
Fig. 1
NOTE: Charge the cleaner for 14-16 hours before initial use. The batteries of a new
cleaner are on a low charge.
6
Fig. 2
Fig. 3