Advertisement
NOTE; At a high altitude (above 3000
feet) or in cold temperatures (below 32 F)
the carburetor fuel mixture may need to be
adjusted for best engine performance..
See "TO ADJUST CARBURETOR"
in the
Service and Adjustments
section of this
manual.
PURGE TRANSMISSION
_CAUTION:
Never engage or disen-
gage freewheel
lever while the engine is
running.
To ensure proper operation and perfor-
mance, it is recommended
that the trans-
mission be purged before operating tractor
for the first time. This procedure will
remove any trapped air inside the trans-
mission which may have developed during
shipping of your tractor.
IMPORTANT:
Should your transmission
require removal for service or replace-
ment, it should be purged after reinstatla-
tion before operating the tractor.
° Place tractor safely on level surface with
engine off and parking brake set.
• Disengage transmission
by placing free-
wheel control in freewheeling
position
(See "TO TRANSPORT"
in this section
of manual).
o Sitting in the tractor seat, start engine.
After the engine is running, move throt-
tle control to slow position. With motion
control lever in neutral (N) position,
slowly disengage clutch/brake
pedal.
o Move motion control lever to full forward
position and hold for five (5) seconds.
Move lever to full reverse position and
hold for five (5) seconds. Repeat this
procedure three (3) times.
NOTE: During this procedure there will be
no movement of drive wheels. The air is
being removed from hydraulic drive sys-
tem.
• Move motion control lever to neutral (N)
position. Shut off engine and set parking
brake.
o Engage transmission
by placing free-
wheel control in driving position (See
'3"0 TRANSPORT"
in this section of
manual).
° Sitting in the tractor seat, start engine.
After the engine is running, move throt-
tle control to half (1/2) speed. With
motion control lever in neutral (N) posi-
tion, slowly disengage
clutch/brake
pedal.
= Slowly move motion control lever for-
ward; after the tractor moves approxi-
mately five (5) feet, slowly move motion
control lever to reverse position. After
the tractor moves approximately
five (5)
feet return the motion control lever to
the neutral (N) position. Repeat this pro-
cedure with the motion control lever
three (3) times.
o Your tractor is now purged and ready for
normal operation.
MOWING TIPS
° Tire chains cannot be used when the
mower housing is attached to tractor.
,, Mower should be properly leveled for
best mowing performance.
See "TO
LEVEL MOWER
HOUSING
in the
Service and Adjustments
section of this
manual.
o The left hand side of mower should be
used for trimming.
° Drive so that dippings are _charged
onto
the area that has been oat. Have the cut area
to the rightof the tractor. This will result in a
more even d'L_tribul_on o f clippings and more
uniform cutting.
o When mowing large areas, start by turn-
ing to the right so that clippings will dis-
charge away from shrubs, fences, drive-
ways, etc. After one or two rounds, mow
in the opposite direction making left
hand turns until finished.
° If grass is extremely tail, it should be
mowed twice to reduce load and possi-
ble fire hazard from dried clippings.
Make first cut relatively high; the second
to the desired height.
° Do not mow grass when it is wet. Wet
grass will plug mower and leave unde-
sirable clumps. Allow grass to dry
before mowing.
o Always operate engine at full throttle
when mowing to assure better mowing
performance and proper discharge of
material. Regulate ground speed by se-
lectin.ga low enough gear to give the
mower the best cutting performance as
well as the quality of cut desired.
° When operating attachments,
select a
ground speed that wilt suit the terrain
and give best performance of the at-
tachment being used.
16
f
1
Advertisement
