Craftsman 358.748240 Instruction Manual page 9

12 amp motor 220 mph/360 cfm electric blower/vacuum
Table of Contents

Advertisement

z_
4rLWARNING:
You MUST make sure
the tubes are secure before using the
unit.
_WARNING:
Do not use the unit
without the tubes or collection bag prop-
erly attached to avoid flying debris and/
or impeller contact which can cause se-
rious injury. Always wear eye protection
to prevent rocks or debris from being
blown or ricocheting into the eyes and
face which can result in blindness or se-
rious injury.
STOPPING
YOUR UNIT
Slide the ON/OFF switch to the OFF
position.
STARTING
YOUR UNIT
Your unit has two run positions,
LOW
and HIGH. Slide the switch to one of
these positions
to turn on the unit.
OPERATING
POSITION
Eye Protection
Eye Protection
Blower
Vacuum
USING YOUR UNIT AS A BLOWER
WARNING:
Inspect the area be-
fore using the unit. Remove all debris
and hard objects such as rocks, glass,
wire, etc., that can ricochet,
be thrown,
or otherwise
cause injury or damage
during operation.
Use your unit as a blower for:
• Sweeping debris or grass clippings
from driveways, sidewalks, patios, etc.
• Blowing grass clippings, straw, or
leaves into piles, or removing debris
from corners, around joints, or be-
tween bricks.
Direct air flow by directing the blower
tube down or to one side. Always work
away from solid objects such as walks,
large stones, vehicles, and fences.
Clean corners by starting in corners and
moving outward. This will help prevent
an accumulation
of debris which could
fly into your face.
Be careful when working near plants.
The force of the air could damage
tender plants.
USING YOUR UNIT AS A VACUUM
_'WARNING:
Do not vacuum
stones,
gravel, metal, broken glass,
etc., to avoid severe damage
to the im-
peller. To avoid the possibility
of elec-
trical shock, do not attempt to vacuum
water or other liquids.
Use your unit as a vacuum
to pick up
dry material such as leaves, grass,
small twigs, and bits of paper.
For best results during vacuum
use,
operate your unit at high speed.
Move slowly back and forth over the
material as you vacuum.
Avoid forc-
ing the unit into a pile of debris as
this can clog the unit.
Keep the vacuum tube about an inch
above the ground for best results.
_WARNING:
If the unit becomes
clogged, stop the unit and unplug the
extension
cord. Wait until the impeller
has completely
stopped turning, then
remove the vacuum
tubes. Carefully
reach into the vacuum
opening and
clear out the clogged
debris.
CUSTOMER
RESPONSIBILITIES
'_
WARNING:
Disconnect
power source before performing
maintenance.
CARE & MAINTENANCE
TASK
Check for loose fasteners and parts
Check for damaged
or worn parts
Inspect and clean unit and labels
Remove and empty collection
bag
Clean collection
bag
WHEN TO PERFORM
Before each use
Before each use
After each use
After each use
Yearly
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents