Assembly; Remove Pressure Washer From Carton; Carton Contents; Assembling Cleaning System - Craftsman 580.752800 Owner's Manual

Yourcleaning system requires someassembly a ndis
ready for useonlyafterit hasbeenproperly serviced
withthe recommended oilandfuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE PRESSURE WASHER
FROM CARTON
1.
2.
3.
4.
5.
Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat
Remove hose reel box, fillers, and parts bag
shipped with cleaning system.
Remove spray gun, nozzle extension, and engine
oil from fillers.
Roll cleaning system out open end of carton.
Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136
Main unit -- cleaning system with wheels and
chemical tanks
Hose reel components
High pressure hose
Spray gun
Nozzle Extension with Quick Connect Fitting and
Tip Holder
Engine oil
Parts bag (which includes items listed below)
Three-pack of chemical concentrates
Owner's manual
Tank labels
Registration card
Bag containing 4 multi-colored Quick Connect
Spray Tips
Handle Fastening Hardware Kit (which includes):
Carriage Bolts (2)
Plastic Knobs (2)
"L" Bolt
Lock Nut
Become familiar with each piece before assembling
the pressure washer. Identify all contents with the
illustration on page 5. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING CLEANING SYSTEM
Your Craftsman cleaning system will need assembly
before operation:
1 Attach handle to main unit
2. Attach hose reel to handle as shown on page 5
according to instruction sheet included with hose
reel.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect high pressure hose to spray gun and
pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect spray tip to nozzle
extension.
Attach Handle
1 Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports
Align Holes_, Handle
Supports
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach plastic knob from inside of unit.
Tighten by hand.
.
Insert "L" bolt through hole just below billboard on
right side of handle (viewing from rear of unit).
Hold hook in place with pliers and tighten Iocknut
with 7/16" wrench.
Spray Gun
Hook
6