Download Print this page

Craftsman 320.10320 Operator's Manual page 8

16.0-volt lithium-ion cordless 3/8-in. drill/driver

Advertisement

_.WARNIING:
READ AND UNDERSTAND ALL INSTRUCTIONS.
Failure to follow all
instructions listed below may result in electric shock, fire andlor serious personal injury.
I_ Before using battery ChargertAdapter,
read all instructions and cautionary markings in this
manual, on battery Charger/Adapter,
battery and product using battery to prevent misuse of
the products and possible injury or damage,.
_CAUTIION:
To reduce the risk of electric shock or damage to the Charger/Adapter
and
battery, charge only lithium-ion rechargeable batteries as specifically designated on your
ChargertAdapter.
Other types of batteries may burst, causing personal injury or damage.
[] Do not use Charger/Adapter
outdoors or expose to wet or damp conditions. Water
entering Charger/Adapter
will increase the risk of electric shock_
11 Use of an attachment
not recommended
or sold by the battery ChargertAdapter
manufacturer
may result in a risk of fire, electric shock or injury to persons.
Following
this rule will reduce the risk of electric shock, fire or serious personal injury.
[] Do not abuse cord or Charger/Adapter.
Never use the cord to carry the Charger!Adapter
o Do not pull the Charger/Adapter
cord rather than the plug when disconnecting
from
receptacle° Damage to the cord or Charger/Adapter
could occur and create an electric shock
hazard. Replace damaged cords immediately_
[] Make sure cord is located so that it will not be stepped
on, tripped
over, come in
contact with sharp edges or moving parts or otherwise
subjected
to damage or stress.
This will reduce the risk of accidental falls, which could cause injury and damage to the cord,
which could result in electric shock_
[] Keep cord and ChargerlAdapter
from heat to prevent damage to housing or internal
parts.
[] Do not let gasoline, oils, petroleum-based
products, etc. come in contact with plastic
parts. They contain chemicals that can damage, weaken or destroy plastic_
[] An extension
cord should
not be used unless absolutely
necessary.
Use of improper
extension cord could result in a risk of fire and electric
shock. If an extension cord must
be used, make sure:
1. That pins on plug of extension cord are the same number, size and shape as hose of plug on
Charger/Adapter _
2. That extension cord is properly wired and in good electrical condition; and
3. That wire size is large enough for AC ampere rating of Charger/Adapter
as specified below:
Cord Length (Feet)
25'
50'
100'
Cord Size (AWG)
16
16
16
NOTE: AWG = American Wire Gauge
[] Do not operate ChargerlAdapter
with a damaged cord or plug, which could cause
shorting and electric shock. If damaged, have the Charger/Adapter
repaired or replaced by an
authorized service technician at Sears Service Center,
[] Do not operate Charger/Adapter
if it has received a sharp blow, been dropped or
otherwise damaged in any way. Take it to an authorized service technician at Sears Service
Center for an electrical check to determine if the Charger/Adapter
is in good working order
[] Do not disassemble
ChargerlAdapter.
Take it to an authorized service technician at Sears
Service Center when service or repair is required. Incorrect reassembly may result in a risk of
electric shock or fire_
[] Unplug
Charger/Adapter
from outlet before attempting any maintenance
or cleaning to
reduce the risk of electric shock,
8

Advertisement

loading