Lubrication - Every 25 Hours - Craftsman C950524302A Owner's Manual

CUSTOMER RESPONSIBILITIES
LUBRICATION - EVERY 25 HOURS
Chute Rotation Gear
Lubricate the chute rotation gear with automotive type oil.
(see Figure 24).
Figure 24
Chains
1. Position speed selector lever in first (1) forward gear.
2. Stand the snow blower up on the auger housing end.
NOTE: When the crank case if filled with oil, do not
leave the snow blower standing up on the auger
housing for an extended period of time.
3. Remove the bottom panel.
4. Lubricatethe chains w_tha chain type lubricant.
5. Wipe the hexahaft and sprockets With 5W30 motor oil.
NOTE: Clean all excess grease or oil found on the
rubber friction wheel or the disc drive plate.
CAUTION: Do not allow grease or oil to contact the
rubber friction wheel or the disc drive plate.
6. Install the bottom panel.
) in
contact with n_llrease or oil
damage to rubber friction wheel
will result.
If grease or oil come in contact with
the disc drive plate or frictionwheel,
make sure to clean the plate and
wheel thoroughlywith a alcohol base
solvent,
Figure 25
22