Service Recommendations - Craftsman C950524302A Owner's Manual

SERVICE RECOMMENDATIONS
SERVICE RECOMMENDATIONS
RRST BEFORE EVERY EVERY EVERY EVERY EVERY BEGINNING
PROCEDURE
2 EACH 8 10 25 50 t00 EACH BEFORE
HOUR USE HOURS HOURS HOURS HOURS HOURS SEASON STORAGE
Tighten all screws and _/ _/ _/
S nuts
N Check TractionClutch
Cable Ad ustment _/ _/
O (See Cab e Ad ustment)
; _l Check Auger clutch Cable
Ad ustment "_
(See Cab e Ad ustmerrt)
O AdjustDriveBelts _ _ _/
W
E LubricateChains and
HexShaft "J "_
R
Lubricate Auger Shaft
(See Shear Bolt Replace-
ment)
E Oil, Check _J
N
G Oil, Change "_
I Check and Clean Spark
N Plug
E Replace Spark Plug
q
,/
.j
,J
,/
,J
Clean and Inspect Spark
Arrestor
q
The warranty on this snow blower does not cover items that
have been subjected to operator abuse or negligence. To re-
ceive full value from the warranty, operator must maintain
snow blower as instructed in this manual. The following Ser-
vice Recommendations is supplied to assist operator to
properly maintain snow blower. This is a check list only. Ad-
justment referred to will be found in Adjustments/Repairs
section of this manual.
Maintenance, replacement, or repair of the emission control
devices and systems can be performed by any non-road en-
gine repair establishment or individual. Regular maintenance
will improve the performance and extend the life of the en-
gine.
AFTER EACH USE
1. Check for any loose or damaged parts.
2. "]]ghten any loose fasteners.
3. Check and maintain the auger.
4. After each use, remove all snow and slush off the snow
blower to prevent freezing of auger or controls.
5. Check controls to make sure they are functioning proper-
ly.
6. If any parts are worn or damaged, replace immediately.
20