Cleaningthe Burnergrates, Burnercaps And Burnerheads - Electrolux EW30DS65GB3 Use & Care Manual

General Care & Cleaning
Orifice
CLEANING THE BURNER G TES, BURNER CAPS AND
BURNER HEADS
m i m [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Surface Burner
Grate
Surface Burner
Cap
Surface Burner
Head
e ctrFi_r e 1
The Grates, Burner Caps and the Large 18k Burner Head
should be routinely cleaned. Keeping the burner ports clean
will prevent improper ignition and an uneven flame. If needed
the fixed burners should be cleaned in place with an humid
cloth (do not spraw water on them).
Refer to the following instructions:
To Remove and Replace the Surface Burner Grate,
Surface Burner Cap and Surface Burner Head -
Remove in the following order; (1st) Surface Burner Grate
(2rid) Surface Burner Cap, (3rd) SurFace Burner Head (See
Figure 1).
Reverse the procedure above to replace the Surface Burner
Cap, Surface Burner Head and Surface Burner Grate. Do
not remove any burner parts from the cooktop until the
burner parts have completely cooled and are safe to
handle. Do not operate the surface burners without the
Surface Burner Heads, Surface Burner Caps and
Surface Burner Grates properly in place.
To Clean the Burner Caps, Burner Heads and Burner Grates - Use a soap-filled
scouring pad or a mild abrasive cleaner to clean the surface burner caps and surface
burner heads The Grates are designed to be Dishwasher safe for cleaning. The ports (or
slots) around the burner heads must be routinely cleaned. If residue still remains in these
ports, use a small-gauge wire or needle to clean the slots or holes being careful not to
damage the electrode. For proper flow of gas and ignition of the burner--DO NOT
ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER
THE GAS ORIFICE HOLDER OPENING. ALWAYS make sure that the surface burner
cap, the surface burner head and the surface burner grate are properly in place whenever
a surface burner is in use.
Surface Burner Head
Surface Burner Grate Surface Burner Caps
THE COOKTOPIS NOT REMOVABLE,Do not attemptto removeorlift the cooktop.
CAUTION
- Usecaution when replacing the burner head so the electrode is not damaged. A damaged
electrode may cause a delayed ignitionor prevent the burner from igniting
- Any additions, changesor conversions required in orderfor this appliance to perform
satisfactorilymust be madeby a qualified service technician.