Electrolux EI30EF55GSC Use & Care Manual page 58

58 Solutions to Common Problems
Prob ÷m solution
: Oven srnokesexcessivelyduring • Control not set properly. Follow broiling instructions
::: broiling under Setting Oven Controls.
• Make sure oven door is opened to broil stop position,
• Meat too close to the broil element. Reposition the broil
rack to provide proper clearance between the meat &
t he ele rne nt. Preh eat t he b roil ele men t for sear ing.
• Meat not properly prepared. Remove excess fat from
meat. Cut remaining fatty edges to prevent curling, but
do not cut into lean.
: • Insert on broiler pan wrong side up & grease not
draining. Always place grid on the broiler pan with ribs
up & slots down to allow grease to drip into pan (some
: :: mode s).
= Grease has built up on oven surfaces. Regular cleaning
is necessary when broiling frequently. Old grease or
.... food spatters cause excessive smoking.
..... Flames inside oven or Excessive SpilloVers in oven. For example this will
smoking from oven vent happen fo r pie Spil!0vers or large amounts of grease
left on the oven bottom. Wipe up excessive spillovers
before starting 0Yen. !f flames or excessive srnoke are
present see AbOut broiling in the Setting Oven
Controls sectionl
Oven control panel beeps & displays
any F code error (for example FIO,
Fll, F13, F14, F15, F20, F23, F25,
F30, F31 or F90)
• Oven control has detected a fault or error condition.
Press CANCEL to clear the display & stop beeping.
Try the bake or broil feature again. If the F code error
repeats, remove power supply to appliance, wait 5
minutes and then repower the appliance and set clock
for the time of day. Try the bake or broil feature again.
If the fault recurs, record fault and call for service.
Oven control panel beeps & cooktop
control displays any E code error
(some models, forexample Ell, E13
or E14}
Cooktop control has detected a fault or error condition.
If the E code error persists, remove power supply to
appliance, wait 5 minutes and then repower the
appliance and set clock for time of day. Try the
cooktop setting again. If the fault recurs, record E code
fault and call for service.