Safety - Electrolux E30MO75HSSA Use & Care Manual

Safety 5
GRO Di i
CTIO
This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a ground-
ing plug. tt must be plugged into a wall receptacle that is properly installed and grounded in accordance
with the National Electrical Code and local codes and ordinances. In the event of an electrical short circuit,
grounding reduces risk of electric shock by providing an escape wire for the electric current.
WARNING
Improper use of the grounding plug can result in a risk of electric shock,
Electrical Requirements
The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more protected electrical supply. It is
recommended that a separate circuit serving only this appliance be provided.
The oven is equipped with a 3-prong grounding plug. It must be plugged into a wall receptacle that is properly
installed and grounded.
A short power-supply cord is provided to reduce risk of becoming entangled in or tripping over a longer cord.
DO NOT USE AN EXTENSION CORD. tf the power supply cord is too short, have a qualified electrician or
serviceperson install an outlet near the appliance.
NOTES:
1. If you have any questions about the grounding or electrical instructions, consult a qualified electrician or
serviceperson.
2. Neither Electrolux nor the dealer can accept any liability for damage to the oven or personal injury resulting
from failure to observe the correct electrical connection procedures.
Federa Communications Commission Radio Frequency
Interference Statement (U.S.A. Onmy)
This equipment generates and uses ISM frequency energy and if not installed and used properly, that is
in strict accordance with the manufacturer's instructions, may cause interference to radio and television
reception. It has been type tested and found to comply with limits for tSM Equipment pursuant to part 18 of
FCC Rules, which are designed to provide reasonable protection against such interference in a residential
installation.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following:
,, Reorient the receiving antenna of the radio or television.
,, Relocate the microwave oven with respect to the receiver.
• Move the microwave oven away from the receiver.
,, Plug the microwave oven into a different outlet so that the microwave oven and the receiver are on
different branch circuits.
The manufacturer is not responsible for any radio or television interference caused by unauthorized
modification to this convection microwave oven. It is the responsibility of the user to correct such interfer-
ence.