Maintenance - Craftsman 315.271410 Owner's Manual

MAINTENANCE
GENERAL
Only the parts shown on parts list, page 11, are intended to
he repaired or replaCed by the customer. All other pads
represent an important pad of the double insulation system
and should be serviced only by a qualified Sears service
technician,
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to vadous typos of commercial SOl-
vents and may be damaged by thair use. Use clean cloths
to remove dirt, carbon duet, etc.
When electric tools are used on fiberglass boats, sports
cars, wallboard, spackling compounds, or plaster, it has
been found that they ara subject to accelerated wear and
passible premature faikJre, as the fiberglass chips and
grlndings are highly abrasive to bearings, brushes,
COmmUtator,etc. Consequently it is not recommended that
this too_be used for extended _nt on any fiberglass material,
wallboard, spacking compounds, or piaster. During any
use On fiberglass it is extremely important that the tooJ is
cleaned frequently by blowing with an air jet,
LUBRICATION
All ofthe bearings in this tool are hibdcated with a sufficientamount of high grade lubricant for the life of the unit under norma;
operating conditions, Therefore. no further lubricationis required.
CRAFTSMAN CHUCK KEY HOLDER
1, F_rmaiaopbyforcingendwithroundholasthroughslotledbele0noppositeend. See Figure13.
2. Place the lOOpor'el the cord and pull it tight. See Figure 14.
3, Mountthechuckkeybytosertingthegearedendthroughtheholelntheholder, Largekeysintbeiargerhoia, smetlerkeys
in the small hole. See Figure 15.
Fig. 13
CORD
Rg. 14 Rg. 15
Page 10