UNPACK
CARTON
& INSTALL
HANDLE
(See Fig. 2)
CAUTION:
Be careful
of exposed
staples when handling
or disposing
of
cartontng
material.
IMPORTANT:
WHEN UNPACKING AND ASSEMBLING
TILLER,
BE CAREFUL
NOT TO STRETCH
OR KINK
CABLE(S),
•
Cut cable ties securing handle column°
•
Slowly lift
handle column up and slip over handie
mount_
•
Remove packing from carton,
•
Secure handle column to handle mount using two (2)
carriage bolts and two (2) flange locknuts. Tighten both
flange ]ocknuts securely,
•
Insert piastic cable clip into hole in handIe column,
•
Route tine control cable through plastic cable clip on
handle column,
,
Remove packing material from handle assembly.
•
Cut cable ties securing tiller to skid.
°
Cut away carton and remove tiller from skid by pulling
backwards.
TINECONTROL
TINECONTROL
CABLE
HANDLE
MOUNT
HANDLE
COLUMN
BOLT
FLANGE
LOCKNUT
CABLE
Cl.IP
INSTALL
DEPTH STAKE
ASSEMBLY
(See Fig. 3)
.
Insert stake support between engine bracket halves
with stake spring down°
NOTE: It may be necessary to loosen nut "A".
•
Bolt stake support to engine brackets with bolts, lock
washers and nuts. Tighten securely. Also tighten nut
"A" if it was necessary to loosen.
.
Depth stake must move freely. If it does not, loosen
support bolto
HANDLE
HEIGHT
•
Handle height may be adjusted to better suit operator°
(See "HANDLE HEIGHT" in the Service and Adjust-
ments section of this manual)°
TILLING
WIDTH
•
Tilling width may be adjusted to better handle your
tilling conditions (See "TiNE ARRANGEMENT"
in the
Service and Adjustments
section of this manual).
TINE OPERATION
•
Check tine operationbefore
first use.
(See "TtNE
OPERATION CHECK inthe Service and Adjustments
section of this manual)_
ENGINE BRACKET
DEPTH
STAKE
HEX BOLTS,
LOCK
WASHERS_
AND HEXNUTS
SUPPORT
BOLT
FIG. 3
FIG. 2