Unpack Carton & Install Handle; Install Depth Stake Assembly; Handle Height; Tilling Width - Craftsman 917.292480 Owner's Manual

UNPACK CARTON & INSTALL
HANDLE
• iLCAUTION:Be carefulof exposed
staples when handlingor disposingof
cadoning material.
IMPORTANT: When unpackingand
assemblingtiller,be carefulnot to stretch
or kink cable(s).
1. Cut cable ties securinghandle
column.
2. Remove all packingfrom cation.
3. Secure handle columnto handle
mountusingtwo (2) carriage bolts
and two (2) flange Iocknuts. Tighten
both flange Iocknutssecurely.
4. Remove packing material from handle
assembly.
5. Route tine controlcable through
plasticcable clip on handle column.
6, Insertplasticcable clip into hole in
handle column.
7, Cut away carton.
8. Cut cable ties securingtillerto skid.
9. Remove tillerfrom skid by pulling
backwards.
Tine
C_tro_
Cable_i _
- Handle
Column
" _'Flange
Locknut
INSTALL DEPTH STAKE ASSEMBLY
1. Loosen nut "A".
2. Insert stake suppod between engine
bracket halves with stake spring
down.
3. Bolt stake support to engine brackets
with bolts, lock washers and nuts.
Tighten securely. Tighten nut "A".
4. Depth stake must move freely. If it
does not, loosen support bolt.
ine BracketHalves
"A" Depth
Support
Bolt
"Stake Spring
.ock Washers,
and hex Nuts
HANDLE HEIGHT
• Handle height may be adjustedto
better suit operator. (See "HANDLE
HEIGHT" in the Service and Adjust-
ments sectionof this manual).
TILLING WIDTH
• Tillingwidthmay be adjustedto better
handle your tillingconditions(See
"FINE ARRANGEMENT _ in the Service
and Adjustmentssection of this
manual).
TINE OPERATION
• Check tine operationbeforefirst use.
(See "FINE OPERATION CHECK"in
the Serviceand Adjustmentssectionof
this manual),
6